CAN Starterkit

Basing on our evaluationboards we composed a starterkit for CAN development .

CAN Debug Tools

We offer the CAN Triggermodule as oscilloscope add-on

CAN Trigger

Trigger add-one for oscilloscopes:

• Trigger on ID, data or error frames
• PC configurable via RS232. During operation no PC needed
• 2 trigger outputs, software configurable
• CAN Data output with TTL Level
• optional: CAN bus galvanic insulated

Additional information:

Product specification of CAN Trigger (PDF-file)

CAN Starter Kit / CAN Monitor

• Complete and stand alone running starterkit for CAN-Applikations with 68HC908AZ60A
• Also available as GZ16/60 version with H-Bridge and System Basis Chip (EB08 GZSBC)
• contains Monitor-Mode-Interface (MONIF08-LC) for Flash-Programming and debugging
• PC software for Flash-Programming included
• Suitable as Mini-CAN-Monitor for testing of CAN systems (runs on 68HC908AZ60A / 68HC908GZ16/60), PC interface via RS232. Software (for µC) is included.
• The CAN-driver-Software for the HC908AZ60 / 68HC908GZ16/60 could be used as base for own designs. The source is included
• The package contains the power supply and all needed wires: unpack and start!

Additional information:

Product specification of CAN Starter Kit / CAN Monitor (PDF-file)

Support and downloads for GZ16 STK

Adaptor 9pin DSUB to terminal clamps (ADP D-SUB M / ADP D-SUB F)

Perfect for prototyping, CAN bus connections, quick connections or debug purposes

• Unambigeous terminal identification: DSub pin 1 is terminal pin 1
• Available with either female or male DSUB connector
• Mini terminal clamps for stranded wire up to 0,75 mm²
• Screwdriver with 2.0 x 0.4 mm blade for the terminals available
• Strain relief with cable tie